Home › SUSPENSION & AXLE › SUSPENSION › FRONT LOWER SUSPENSION ARM

FRONT LOWER SUSPENSION ARM > INSTALLATION

for Preparation Click here



1. INSTALL FRONT LOWER SUSPENSION ARM
  1. Install the front lower arm bushing stopper to the front lower suspension arm.

  1. Install the front lower suspension arm to the front frame assembly with the 3 bolts and nut, but do not tighten them yet.



    C167143E01
  1. Tighten the 3 bolts in numerical order shown in the illustration.

    Torque:
    Bolt 1, 2:
    200 N*m{ 2039 kgf*cm , 147 ft.*lbf }
    Bolt 3:
    206 N*m{ 2100 kgf*cm , 152 ft.*lbf }

    HINT:
    Start installing the bolts from the front side of the vehicle.



2. CONNECT FRONT FRAME ASSEMBLY


  1. Temporarily install the engine assembly with transaxle with the 9 nuts and 2 bolts.


    A172974E01



    A172975E01
  1. Tighten the 4 nuts.

    Torque:
    A:
    87 N*m{ 887 kgf*cm , 64 ft.*lbf }
    B:
    52 N*m{ 525 kgf*cm , 38 ft.*lbf }



    A172976E01
  1. Tighten the 4 nuts.

    Torque:
    A:
    95 N*m{ 969 kgf*cm , 70 ft.*lbf }
    B:
    87 N*m{ 887 kgf*cm , 64 ft.*lbf }



    A172977E01
  1. Tighten the 4 nuts.

    Torque:
    A:
    95 N*m{ 969 kgf*cm , 70 ft.*lbf }
    B:
    87 N*m{ 887 kgf*cm , 64 ft.*lbf }



    A171830
  1. Tighten the 2 bolts.

    Torque:
    78 N*m{ 795 kgf*cm , 58 ft.*lbf }



    A171835
  1. Connect the duty vacuum switching valve connector and clamp.



  1. Install the 5 hole plugs.


    A172972E01



3. REMOVE ENGINE HANGERS


    A129635E01
  1. Remove the 4 bolts and 2 engine hangers.



4. INSTALL POWER STEERING LINK ASSEMBLY


    C166343
  1. Install the power steering link assembly with the 2 bolts and 2 nuts.

    Torque:
    70 N*m{ 713 kgf*cm , 51 ft.*lbf }

    NOTICE:
    1. Make sure to tighten the bolts starting from the left side of the vehicle.
    2. Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut fixed.



5. INSTALL FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY


6. INSTALL NO. 1 FRONT STABILIZER BRACKET LH


    C167140
  1. Install the No. 1 front stabilizer bracket LH to the front frame assembly with the 2 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



7. INSTALL NO. 1 FRONT STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.



8. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Install engine assembly with transaxle (Click here).