REAR STRUT ROD > INSTALLATION |
| 1. TEMPORARILY INSTALL REAR STRUT ROD ASSEMBLY (for 2WD) |
![]() |
Check that the identification mark of the rear strut rod assembly is positioned on the inner side of the vehicle.
Temporarily install the rear strut rod assembly with the 2 bolts and the 2 nuts.
| 2. TEMPORARILY INSTALL REAR STRUT ROD ASSEMBLY (for 4WD) |
![]() |
Check that the identification mark of the rear strut rod assembly is positioned on the inner side of the vehicle.
Temporarily install the rear strut rod assembly with the 2 bolts and the 2 nuts.
| 3. STABILIZE SUSPENSION (for 2WD) |
![]() |
Jack up the rear axle carrier, placing a wooden block underneath to avoid damage. Apply load to the suspension so that the installed bolt of the rear No. 1 suspension arm (inner side) is horizontally aligned with the center of the rear axle hub.
| 4. STABILIZE SUSPENSION (for 4WD) |
![]() |
Jack up the rear axle carrier sub-assembly, placing a wooden block underneath to avoid damage. Apply load to the suspension so that the rear drive shaft assembly is positioned horizontally.
| 5. FULLY TIGHTEN REAR STRUT ROD ASSEMBLY (for 2WD) |
![]() |
Fully tighten the 2 bolts.
| 6. FULLY TIGHTEN REAR STRUT ROD ASSEMBLY (for 4WD) |
![]() |
Fully tighten the bolt.
![]() |
Fully tighten the bolt.
| 7. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Install the No. 3 parking brake cable assembly with the bolt and the nut.
| 8. INSTALL REAR WHEEL |