Home › SUSPENSION & AXLE › SUSPENSION › REAR STRUT ROD

REAR STRUT ROD > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR WHEEL


2. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY


    C165998
  1. Remove the bolt and the nut, and separate the No. 3 parking brake cable assembly.



3. REMOVE REAR STRUT ROD ASSEMBLY (for 2WD)


    C167803
  1. Remove the 2 bolts, the 2 nuts, and the rear strut rod assembly.

    NOTICE:
    Since stopper nuts are used, loosen the bolts.



4. REMOVE REAR STRUT ROD ASSEMBLY (for 4WD)


    C165999
  1. Remove the 2 bolts, the 2 nuts, and the rear strut rod assembly.

    NOTICE:
    Since stopper nuts are used, loosen the bolts.