Home › SUSPENSION & AXLE › SUSPENSION › REAR LOWER ARM (for 2WD)

REAR LOWER ARM (for 2WD) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE DECK BOARD ASSEMBLY


    B173240
  1. Remove the deck board assembly.



2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Tonneau Cover)


    B173242
  1. Disengage the 2 guides and remove the No. 3 deck board sub-assembly.



3. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY (w/ Tonneau Cover)


    B173244
  1. Disengage the 2 guides and remove the No. 2 deck board sub-assembly.



4. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
  1. Remove the tonneau cover assembly.



5. REMOVE REAR MAT


    B173249
  1. Remove the rear mat.



6. REMOVE DECK TRIM SERVICE HOLE COVER


7. REMOVE LOWER SPARE WHEEL CARRIER HINGE COVER (w/ Cover)


8. REMOVE SPARE TIRE


9. REMOVE SPARE WHEEL CARRIER LOCK COVER (w/ Cover)


10. REMOVE REAR WHEEL


11. SEPARATE REAR STABILIZER LINK ASSEMBLY LH


    C167797E01
  1. Remove the nut and separate the rear stabilizer link assembly LH from the rear stabilizer bar.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.



12. SEPARATE REAR STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as the LH side.



13. REMOVE REAR STABILIZER BAR


    C170677E01
  1. Remove the 4 bolts and rear stabilizer bar.



14. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY


C167804
  1. Remove the bolt and the nut, and separate the rear No. 2 suspension arm assembly from the rear axle carrier sub-assembly.

    NOTICE:
    Since a stopper nut is used, loosen the bolt.

  1. Remove the bolt and the rear No. 2 suspension arm assembly.



15. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY


C167805
  1. Remove the bolt and the nut, and separate the rear No. 1 suspension arm assembly from the rear axle carrier sub-assembly.

    NOTICE:
    Since a stopper nut is used, loosen the bolt.

  1. Remove the bolt and the rear No. 1 suspension arm assembly.