Home › SUSPENSION & AXLE › SUSPENSION › REAR STABILIZER BAR (for 2WD)

REAR STABILIZER BAR (for 2WD) > INSTALLATION

for Preparation Click here



1. INSTALL REAR STABILIZER BUSHING (for LH Side)


    C167802
  1. Install the rear stabilizer bushing.



2. INSTALL REAR STABILIZER BUSHING (for RH Side)

HINT:
Perform the same procedure as the LH side.



3. INSTALL REAR NO. 1 STABILIZER BAR BRACKET (for LH Side)


    C167800
  1. Install the rear stabilizer bar bracket.



4. INSTALL REAR NO. 1 STABILIZER BAR BRACKET (for RH Side)

HINT:
Perform the same procedure as the LH side.



5. INSTALL REAR STABILIZER BAR


    C170677E01
  1. Install the rear stabilizer bar with the 4 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }



6. INSTALL REAR STABILIZER LINK ASSEMBLY LH


    C167798E02
  1. Install the rear stabilizer link assembly LH to the rear shock absorber with coil spring LH with the nut.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.



    C167797E02
  1. Install the rear stabilizer link assembly LH to the rear stabilizer bar with the nut.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.



7. INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as the LH side.



8. INSTALL REAR WHEELS

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }