Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Parking Brake Switch Circuit

for Preparation Click here


DESCRIPTION

The main body ECU receives a parking brake switch signal to control the daytime running light system.

WIRING DIAGRAM


B110595E07


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn Techstream on.

  1. Select the following menu items: Body Electrical / Main Body / Data List.

  1. Read the display on Techstream.

    Main Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Parking Brake SW
    Parking brake SW signal / ON or OFF
    ON: Parking brake switch is ON
    OFF: Parking brake switch is OFF
    -

    OK:
    Normal conditions listed above are displayed.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT PARKING BRAKE SWITCH ASSEMBLY


    E071372E03
  1. Remove the parking brake switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Switch body
    Shaft is pushed in (OFF)
    10 kΩ or higher
    1 - Switch body
    Shaft is not pushed in (ON)
    Below 1 Ω



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (SWITCH - INSTRUMENT PANEL JUNCTION BLOCK)


    E121500E03
  1. Disconnect the 1C instrument panel junction block assembly connector.

  1. Disconnect the A17 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1C-14 - A17-1
    Always
    Below 1 Ω
    1C-14 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)