LIGHTING SYSTEM > Front Fog Light Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM |
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn Techstream on.
Select the following menu items: Body Electrical / Main Body / Active Test.
Check that the relay operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Front Fog Light Relay | Front fog light relay | ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT FUSE (FR FOG) |
Remove the FR FOG fuse from the instrument panel junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| FR FOG fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT FOG LIGHT RELAY (FOG) |
![]() |
Remove the front fog light relay from the instrument panel junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Apply the battery voltage between terminals 1 and 2 | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (BATTERY - FRONT FOG LIGHT RELAY) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Front fog light relay terminal 5 - Body ground | Always | 11 to 14 V |
| Front fog light relay terminal 1 - Body ground | Light control switch OFF → TAIL | Below 1 V → 11 to 14 V |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (FRONT FOG LIGHT RELAY - MAIN BODY ECU) |
Disconnect the D8 main body ECU connector.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Front fog light relay terminal 2 - D8-4 (FFGO) | Always | Below 1 Ω |
| D8-4 (FFGO) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.INSPECT MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) |
Reconnect the D8 main body ECU connector.

Install the front fog light relay to the instrument panel junction block.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D8-4 (FFGO) - Body ground | Light control switch in HEAD, front fog light switch OFF → ON | 11 to 14 V → Below 1 V |
|
| ||||
| OK | ||
| ||