Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Stereo Component Amplifier Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the stereo component amplifier.

WIRING DIAGRAM


E153674E01


INSPECTION PROCEDURE

1.INSPECT STEREO COMPONENT AMPLIFIER


    I101985E06
  1. Disconnect the stereo component amplifier connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    N15-6 (GND) - Body ground
    Always
    Below 1 Ω
    N15-7 (GND2) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    N16-1 (+B) - N15-6 (GND)
    Always
    11 to 14 V
    N16-5 (+B2) - N15-6 (GND)
    Always
    11 to 14 V
    N14-12 (ACC) - N15-6 (GND)
    Ignition switch on (ACC)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)