NAVIGATION SYSTEM > Radio Broadcast cannot be Received or Poor Reception |
| 1.CHECK NAVIGATION RECEIVER ASSEMBLY |
Check the radio's automatic station search function.
Check the radio's automatic station search function by activating it.
|
| ||||
| OK | ||
| ||
| 2.CHECK OPTIONAL COMPONENTS |
Check optional components (sun-shade film, telephone antenna, etc.).
Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
|
| ||||
| OK | ||
| ||
| 3.CHECK NAVIGATION RECEIVER ASSEMBLY |
![]() |
Preparation for check
Remove the antenna plug from the navigation receiver assembly.
Check for noise
Turn the ignition switch on (ACC) with the navigation receiver assembly connector connected.
Turn the radio on and tune into AM mode.
Place a screwdriver, thin wire, or other metal object on the navigation receiver assembly's antenna jack and check that noise can be heard from the speaker.
|
| ||||
| OK | |
| 4.CHECK GLASS ANTENNA |
![]() |
Check for continuity of the antenna.
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - ANTENNA AMPLIFIER) |
![]() |
Disconnect navigation receiver assembly connector E2.
![]() |
Disconnect antenna amplifier connector E7.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E2-13 (ANT) - E7-1 (B) | Always | Below 1 Ω |
| E2-13 (ANT) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.INSPECT NAVIGATION RECEIVER ASSEMBLY |
![]() |
Reconnect navigation receiver assembly connector E2.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-1 (B) - Body ground | Ignition switch on (IG) Radio switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 7.CHECK ANTENNA CORD |
Remove the antenna plug of the navigation receiver assembly and antenna.
Measure the resistance between the antenna and navigation receiver assembly to check for an open circuit in the antenna cord.
Measure the resistance between the antenna cord and body ground to check for a short circuit in the antenna cord.
|
| ||||
| OK | |
| 8.REPLACE ANTENNA AMPLIFIER |
Replace the antenna amplifier and check if radio broadcasts can be received normally (Click here).
|
| ||||
| OK | ||
| ||