Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Start the engine and warm it up.

  1. Select Active Test menu on the Techstream.

  1. Check the engine speed when the OCV (camshaft timing oil control valve) is operated by Techstream.

    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Control the VVT Linear (Bank 1)
    VVT (bank 1 intake side)
    Between -128 and 127%
    This valve added to present OCV control duty
    100%: Maximum advance
    -100%: Maximum retard
    Engine stalls or idles roughly when VVT actuator operated by 100%. Test is possible while idling.
    Control the VVT System (Bank 1)
    Oil control valve
    ON/OFF
    1. Engine stalls or idles roughly when oil control valve turned ON
    2. Normal engine running or idling when oil control valve OFF
    Control the VVT Linear (Bank 2)
    VVT (bank 2 intake side)
    Between -128 and 127%
    Same as above
    Control the VVT System (Bank 2)
    Oil control valve
    ON/OFF
    1. Engine stalls or idles roughly when oil control valve turned ON
    2. Normal engine running or idling when oil control valve OFF
    Control the VVT Exhaust Linear (Bank 1)
    VVT (bank 1 exhaust side)
    Between -128 and 127%
    This valve added to present OCV control duty
    100%: Maximum retard
    -100%: Maximum advance
    Same as above
    Control the VVT Exhaust Linear (Bank 2)
    VVT (bank 2 exhaust side)
    Same as above
    Same as above