Home › ENGINE › 2GR-FE EMISSION CONTROL › CANISTER

CANISTER > REMOVAL

for Preparation Click here



1. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    A170139
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the exhaust pipe support and remove the tail exhaust pipe assembly.

  1. Remove the gasket from the center exhaust pipe assembly.



2. REMOVE CENTER EXHAUST PIPE ASSEMBLY


    A170125
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the 3 exhaust pipe supports and remove the center exhaust pipe assembly.

  1. Remove the gasket from the No. 3 exhaust pipe sub-assembly.



3. REMOVE NO. 3 FRONT FLOOR HEAT INSULATOR


    A170905
  1. Remove the 4 bolts and No. 3 front floor heat insulator.



4. REMOVE CHARCOAL CANISTER ASSEMBLY


    A170906
  1. Disconnect the hose and connector.



    A170907
  1. Disconnect the tube.



    A170908E01
  1. Disconnect the charcoal canister fuel hose from the charcoal canister assembly.

    1. Pinch the retainer and pull out the quick connector with the quick connector pushed to the pipe side to disconnect the charcoal canister fuel hose from the charcoal canister assembly.

      NOTICE:
      1. Remove dirt or foreign objects on the quick connector before this work.
      2. Do not allow any scratches or foreign objects on the parts when disconnecting as the fuel hose connector has the O-ring that seals the pipe.
      3. Perform this work by hand. Do not use any tools.
      4. Do not forcibly bend, twist or turn the nylon tube.
      5. Protect the connected part by covering it with a vinyl bag after disconnecting the charcoal canister fuel hose.
      6. If the quick connector and pipe are stuck, push and pull them to release.



    A170909
  1. Remove the 3 nuts and charcoal canister assembly.