EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK PURGE VSV |
![]() |
Enter the following menus:
Techstream - Select: Powertrain / Engine and ECT / Active test / Activate the VSV for Evap Control.
Disconnect the hose (connected to the canister) from the purge VSV.
Start the engine.
Using the tester, turn off the purge VSV (EVAP VSV: OFF).
Use your finger to confirm that the purge VSV has no suction.
Using the tester, turn on the purge VSV (EVAP VSV: ON).
Use your finger to confirm that the purge VSV has suction.
| 2. INSPECT FUEL CUT OFF / RESTART RPM |
Increase the engine speed to at least 3500 rpm.
Use a sound scope to check for injector operating sounds.
Check that when the throttle lever is released, injector operation sound stops momentarily and then resumes (at 1400 rpm).
| Item | Specified Condition |
| Fuel injector restart rpm | 1400 rpm |
| 3. VISUALLY INSPECT HOSE, CONNECTIONS AND GASKETS |
![]() |
Check for cracks, leaks or damage.
| 4. CHECK AIR INLET LINE |
![]() |
Disconnect the air inlet line hose from the charcoal canister.
Check that air can flow freely into the air inlet line.
If air cannot flow freely into the air inlet line, repair or replace it.
Reconnect the air inlet line hose to the charcoal canister.