GLASS HATCH OPENER SYSTEM > TERMINALS OF ECU |
| CHECK MAIN BODY ECU |

Disconnect the 1A, 1D and 1F Junction block connectors.
Measure the voltage and resistance between the specified terminals of the wire harness side connectors and body ground.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| 1A-1 - Body ground | B - Body ground | Battery power supply | Always | 11 to 14 V |
| 1D-16 (ALTB) - Body ground | W - Body ground | Generator power supply | Always | 11 to 14 V |
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| 1F-10 (GND1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| 1D-16 (ALTB) - Body ground | W - Body ground | Ground | Always | Below 1 Ω |
Reconnect the 1A, 1D and 1F Junction block connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| D8-20 (GCTY) - Body ground | P - Body ground | Glass hatch courtesy switch input | Glass hatch is open | Below 1 V |
| Glass hatch is closed | 11 to 14 V | |||
| D10-8 (GHSW) - Body ground | O - Body ground | Glass hatch open signal input | Glass hatch is open | Below 1 V |
| Glass hatch is closed | 11 to 14 V | |||
| D7-26 (GRY2) - Body ground | Y - Body ground | NO.1 glass hatch relay signal | Ignition switch: on (IG) Glass hatch open switch: on | Below 1 V |
| Ignition switch: on (IG) Glass hatch open switch: off | 11 to 14 V | |||
| D7-15 (GRY1) - Body ground | V - Body ground | NO.2 glass hatch relay signal | Ignition switch: on (IG) Glass hatch open switch: on | Below 1 V |
| Ignition switch: on (IG) Glass hatch open switch: off | 11 to 14 V |