Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY


    B162671E09
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Light control switch:
    Tester Connection
    Switch Condition
    Specified Condition
    12 (EL) - 20 (H) - 18 (T) -19 (A)
    OFF
    10 kΩ or higher
    12 (EL) - 18 (T)
    TAIL
    Below 1 Ω
    12 (EL) - 20 (H) - 18 (T)
    HEAD
    Below 1 Ω
    12 (EL) - 19 (A)
    AUTO
    Below 1 Ω
    Dimmer switch:
    Tester Connection
    Switch Condition
    Specified Condition
    17 (HF) - 12 (EL)
    HIGH FLASH
    Below 1 Ω
    11 (HU) - 12 (EL)
    HIGH
    Below 1 Ω
    Turn signal switch:
    Tester Connection
    Switch Condition
    Specified Condition
    13 (TR) - 12 (EL) - 15 (TL)
    OFF
    10 kΩ or higher
    13 (TR) - 12 (EL)
    RH
    Below 1 Ω
    15 (TL) - 12 (EL)
    LH
    Below 1 Ω
    Fog light switch:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (LFG) - 4 (BFG)
    OFF
    10 kΩ or higher
    3 (LFG) - 4 (BFG)
    FRONT
    Below 1 Ω

    If the result is not as specified, replace the headlight dimmer switch assembly.