AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier |

| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER) |
![]() |
Disconnect the connectors from the radio receiver and the stereo component amplifier.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E2-9 (L+) - N14-3 (L+) | Always | Below 1 Ω |
| E2-19 (L-) - N14-2 (L-) | Always | Below 1 Ω |
| E2-8 (R+) - N14-5 (R+) | Always | Below 1 Ω |
| E2-18 (R-) - N14-4 (R-) | Always | Below 1 Ω |
| E2-10 (SLD) - N14-6 (SLD) | Always | Below 1 Ω |
| E2-9 (L+) - Body ground | Always | 10 kΩ or higher |
| E2-19 (L-) - Body ground | Always | 10 kΩ or higher |
| E2-8 (R+) - Body ground | Always | 10 kΩ or higher |
| E2-18 (R-) - Body ground | Always | 10 kΩ or higher |
| E2-10 (SLD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||