Home › ENGINE › 2GR-FE FUEL › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FUEL SENDER GAUGE ASSEMBLY


    A175693E01
  1. Remove the fuel sender gauge assembly.

  1. Check the operation of the float moving smoothly between F and E.

  1. Measure the resistance between terminals 2 (FE) and 3 (FS) of the connector according to the value(s) in the table below.

    OK:
    Float Level
    Resistance (Ω)
    F
    3.0 to 5.0
    E
    109.0 to 111.0

    HINT:
    If the value is not as specified, replace the fuel sender gauge assembly.