METER / GAUGE SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT SPEEDOMETER |
Check the operation.
Using a speedometer tester (calibrated chassis dynamometer), check the speedometer indication according to the table below.
| Chassis Dynamometer Indication | Acceptable Range |
| 20 mph | 20.0 to 23.0 mph |
| 40 mph | 40.0 to 43.5 mph |
| 60 mph | 60.0 to 64.0 mph |
| 80 mph | 80.0 to 84.5 mph |
| 100 mph | 100.0 to 105.0 mph |
| 120 mph | 120.0 to 125.5 mph |
| 140 mph | 140.0 to 146.0 mph |
| Chassis Dynamometer Indication | Acceptable range Data in ( ) is for reference |
| 20 km/h | (17.5 to 21.5 km/h) |
| 40 km/h | 38.0 to 42.0 km/h |
| 60 km/h | 58.0 to 63.0 km/h |
| 80 km/h | 78.0 to 84.0 km/h |
| 100 km/h | 98.5 to 104.5 km/h |
| 120 km/h | 119.0 to 125.0 km/h |
| 140 km/h | 139.0 to 146.0 km/h |
| 160 km/h | 159.0 to 167.0 km/h |
| 180 km/h | 179.0 to 188.0 km/h |
| 200 km/h | 199.0 to 209.0 km/h |
| 220 km/h | 219.0 to 230.0 km/h |
| 240 km/h | 239.0 to 251.0 km/h |
Check the deviation from the acceptable range of the speedometer indication.
| 2. INSPECT TACHOMETER |
Connect a tune-up tachometer, and start the engine.
Compare the test results with the tachometer indications.
| Tune-up Tachometer indication (rpm) | Acceptable range Data in ( ) is for reference |
| 700 | 630 to 770 |
| 1,000 | (900 to 1100) |
| 2,000 | (1850 to 2150) |
| 3,000 | 2800 to 3200 |
| 4,000 | (3800 to 4200) |
| 5,000 | 4800 to 5200 |
| 6,000 | (5750 to 6250) |
| 7,000 | 6700 to 7300 |
| 8,000 | (7700 to 8300) |