AUTOMATIC TRANSAXLE SYSTEM > Transmission Control Switch Circuit |

| 1.CHECK HARNESS AND CONNECTOR (BATTERY - SHIFT LOCK CONTROL UNIT ASSEMBLY) |
![]() |
Disconnect the transmission control switch connector of shift lock control unit assembly.
Turn the ignition switch on (IG), and measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D28-3 (IG) - Body ground | Ignition switch on (IG) | 11 to 14 V |
| ↑ | Ignition switch off | Below 1 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (SHIFT LOCK CONTROL UNIT ASSEMBLY - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D28-5 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY |
![]() |
Measure the resistance between each terminal of shift lock control unit assembly when the shift lever is moved to each position.
| Tester Connection | Shift Position | Specified Condition |
| 3 - 7 | S, "+" and "-" | Below 1 Ω |
| ↑ | Except S, "+" and "-" | 10 kΩ or higher |
| 2 - 5 | Press continuously "+" (Up shift) | Below 1 Ω |
| ↑ | S | 10 kΩ or higher |
| 1 - 5 | Press continuously "-" (Down shift) | Below 1 Ω |
| ↑ | S | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SHIFT LOCK CONTROL UNIT ASSEMBLY - ECM) |
![]() |
Connect the transmission control switch connector of shift lock control unit assembly.
Disconnect the ECM connector.
Measure the voltage according to the value(s) in the table below when the shift lever is moved to each position.
| Tester Connection | Shift Position | Specified Condition |
| D36-20 (S) - Body ground | S, "+" and "-" | 11 to 14 V |
| ↑ | Except S, "+" and "-" | Below 1 V |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.
| Tester Connection | Shift Position | Specified Condition |
| D36-6 (SFTU) - Body ground | Press continuously "+" (Up shift) | Below 1 Ω |
| ↑ | S | 10 kΩ or higher |
| D36-5 (SFTD) - Body ground | Press continuously "-" (Down shift) | Below 1 Ω |
| ↑ | S | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||