Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT DIFFERENTIAL RING GEAR


    C050182E03
  1. Place matchmarks on the ring gear and differential case.



    C050183E02
  1. Remove the 16 bolts.



    C050184E02
  1. Using a plastic hammer, tap the ring gear to remove it from the case.



2. REMOVE FRONT DIFFERENTIAL SIDE GEAR


    C050187E02
  1. Remove the differential LH case from the differential case assembly.



    C050188E04
  1. Remove the No. 2 differential case from the differential case LH.



    D101210E03
  1. Remove the front differential side gear, front differential side gear thrust washer, conical spring, and No. 2 center differential side gear thrust washer from the differential case LH.



    D025610E01
  1. Using a snap ring expander, remove the pinion shaft spacer snap ring.



    C050190E01
  1. Using a pin punch and hammer, remove the 3 straight pins.



    C050191E01
  1. Remove the center differential pinion shaft and 2 differential pinion shafts.



    C050943E01
  1. Remove the 4 front differential pinions, 4 front differential pinion thrust washers, front differential pinion shaft holder, front differential side gear, and front differential side gear thrust washer.



3. REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING


    D025597E05
  1. Using SST, remove the front differential case rear tapered roller bearing from the differential case.

    SST
    09950-00020  
    09950-00030  
    09950-60010   (09951-00480)



    D025598E03
  1. Using SST, remove the front differential case rear tapered roller bearing outer race and differential case washer.

    SST
    09308-00010  

    NOTICE:
    1. When replacing the bearing, be sure to replace both outer and inner races.
    2. When replacing the bearing, be sure to replace both left and right bearings as a set.



4. REMOVE CENTER DIFFERENTIAL PINION


    C050193E01
  1. Using a "TORX" socket (T50), remove the 15 bolts.



    C050230E02
  1. Place matchmarks on the differential intermediate case and differential case.

  1. Remove the differential intermediate case from the differential case RH.



    C050196E02
  1. Remove the center differential side gear, conical spring washer, and No. 1 center differential side gear thrust washer RH from the differential case RH.



    C050194E01
  1. Remove the differential spider, 5 center differential pinions, and 5 center differential pinion thrust washers from the differential intermediate case.



5. REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING


    D025611E01
  1. Using SST, remove the front differential case front tapered roller bearing from the differential case.

    SST
    09950-00020  
    09950-00030  
    SST
    09950-60010   (09951-00600)



    D025596E03
  1. Using SST, remove the front differential case front tapered roller bearing outer race and differential case washer.

    SST
    09308-00010  



6. REMOVE TRANSAXLE HOUSING OIL SEAL


    D025599E02
  1. Using SST, remove the oil seal.

    SST
    09950-70010   (09951-07100)
    SST
    09649-17010  



7. REMOVE DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL


    D025600E02
  1. Using SST, remove the oil seal.

    SST
    09950-70010   (09951-07100)
    09608-10010