Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSPECTION

for Preparation Click here



1. INSPECT TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System)


    E074066E09
  1. Connect the (+) lead from battery to the terminal 2 and the (-) lead to terminal 6.

  1. Check that the ignition key cylinder light comes on.

    OK:
    The ignition key cylinder light comes on

    If the result is not as specified, replace the transponder key amplifier.



2. INSPECT KEY CYLINDER LIGHT ASSEMBLY (w/o Engine Immobiliser System)


    E151696E02
  1. Connect the (+) lead from battery to the terminal 1 and the (-) lead to terminal 2.

  1. Check that the ignition key cylinder light comes on.

    OK:
    The ignition key cylinder light comes on

    If the result is not as specified, replace key cylinder light assembly.