CAN COMMUNICATION SYSTEM > Combination Meter ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Combination Meter ECU Communication Stop Mode |
|
|

| 1.CHECK FOR OPEN IN CAN NO. 1 BUS WIRE (COMBINATION METER MAIN BUS WIRE) |
Turn the ignition switch off.
Disconnect the combination meter connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E1-25 (CANH) - E1-26 (CANL) | Ignition switch off | 108 to 132 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
Disconnect the combination meter connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E1-20 (ES) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E1-1 (IG+) - Body ground | Ignition switch on (IG) | 10 to 14 V |
| E1-21 (B) - Body ground | Always | 10 to 14 V |
|
| ||||
| OK | ||
| ||