CAN COMMUNICATION SYSTEM > Main Body ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Main Body ECU Communication Stop Mode |
|
|

| 1.CHECK CAN BUS LINE FOR DISCONNECTION (MAIN BODY ECU BRANCH WIRE) |
Turn the ignition switch off.
Disconnect the main body ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D9-5 (CANH) - D9-6 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 2.CHECK POWER SOURCE CIRCUIT (MAIN BODY ECU) |
Check the main body ECU power source circuit (Click here).
|
| ||||
| OK | ||
| ||