Home › TRANSMISSION ยท U151E AUTOMATIC TRANSAXLE › SECOND BRAKE PISTON

SECOND BRAKE PISTON > REASSEMBLY

for Preparation Click here



1. INSTALL 2ND BRAKE PISTON O-RING


    D026706E02
  1. Coat 2 new O-rings with ATF, and install them in the 2nd brake piston.

    NOTICE:
    Make sure that the O-ring is not twisted or pinched.



2. INSTALL 2ND BRAKE PISTON


    D026775
  1. Coat the 2nd brake piston with ATF and install it to the 2nd brake cylinder.

    NOTICE:
    Be careful not to damage the O-ring.



3. INSTALL 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY


    D026704E05
  1. Install the 2nd brake piston return spring.

    NOTICE:
    After installing the spring sub-assembly, check that all of the springs are engaged in the piston correctly.



    D026703E01
  1. Place SST on the piston return spring and compress the piston return spring with a press.

    SST
    09387-00060  

  1. Using a screwdriver, install the snap ring.

  1. Be sure that the end gap of the snap ring is not aligned with the spring retainer claw.

    NOTICE:
    Stop the press when the spring seat is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove. This prevents the spring seat from being deformed.