DTC B1442/42 Air Inlet Damper Control Servo Motor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1442/42 | Air inlet damper position does not change even if air conditioning amplifier operates air inlet damper control servo motor |
|

| 1.READ VALUE USING TECHSTREAM |
Connect Techstream to the DLC3.
Turn the ignition switch on (IG) and turn Techstream main switch on.
Select the items below in the Data List, and read the value displayed on Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Air Inlet Damper Targ Pulse | Air inlet control servo motor target pulse / Min.: 0, Max.: 255 | RECIRCULATION: 7 (pulse) FRESH: 28 (pulse) | - |
| Result | Proceed to |
| NG | A |
| OK (Checking from PROBLEM SYMPTOMS TABLE) | B |
| OK (Checking from DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.REPLACE AIR INLET CONTROL SERVO MOTOR |
Replace the air inlet control servo motor.
| NEXT | |
| 3.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||