DTC B1443/43 Air Outlet Damper Control Servo Motor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1443/43 | Air outlet damper position does not change even if air conditioning amplifier operates air outlet control servo motor |
|

| 1.READ VALUE USING TECHSTREAM |
Connect Techstream to the DLC3.
Turn the ignition switch on (IG) and turn Techstream main switch on.
Select the items below in the Data List, and read the value displayed on Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Air Outlet Servo Pulse(D) | Air outlet control servo motor target pulse / Min.: 0, Max.: 255 | FACE: 8 (pulse) B/L: 30 (pulse) FOOT: 67 (pulse) FOOT/DEF: 80 (pulse) DEF: 97 (pulse) | - |
| Result | Proceed to |
| NG | A |
| OK (Checking from PROBLEM SYMPTOMS TABLE) | B |
| OK (Checking from DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.REPLACE AIR OUTLET CONTROL SERVO MOTOR |
Replace the air outlet control servo motor.
| NEXT | |
| 3.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||