DTC B1451/51 Compressor Solenoid Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1451/51 | Open or short in solenoid of externally changeable compressor circuit |
|

| 1.READ VALUE USING TECHSTREAM |
Connect Techstream to the DLC3.
Turn the ignition switch on (IG) and turn Techstream main switch on.
Select the items below in the Data List, and read the value displayed on Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Regulator Control Current | Regulator control current / Min.: 0 A Max.: 0.997 A | Value changes between 0 A and 0.997 A in accordance with compressor operation | - |
| Result | Proceed to |
| NG | A |
| OK (Checking from PROBLEM SYMPTOMS TABLE) | B |
| OK (Checking from DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT COMPRESSOR AND MAGNETIC CLUTCH |
![]() |
Disconnect the compressor and magnetic clutch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 6 | 25°C (77°F) | 10.1 to 11.1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (COMPRESSOR AND MAGNETIC CLUTCH - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the B45 compressor and magnetic clutch connector.
Disconnect the D37 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B45-3 (SOL+) - D37-2 (SOL+) | Always | Below 1 Ω |
| B45-3 (SOL+) - Body Ground | Always | 1 MΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (COMPRESSOR AND MAGNETIC CLUTCH - BODY GROUND) |
![]() |
Disconnect the B45 compressor and magnetic clutch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B45-6 (SOL-) - Body Ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||