AIR CONDITIONING SYSTEM (for Manual Air Conditioning System) > Blower Motor Circuit |


| 1.PERFORM ACTIVE TEST USING TECHSTREAM |
Connect Techstream to the DLC3.
Turn the ignition switch on (IG) and turn Techstream main switch on.
Select the item below in the Active Test, and then check that the blower motor operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Blower Motor | Blower motor | Min.: 0, Max.: 31 | - |
| Result | Proceed to |
| NG (blower motor does not operate) | A |
| NG (blower motor operates but does not change speed) | B |
| OK | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT FUSE (HTR-H) |
Remove the HTR H-fuse from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| HTR H-fuse | Always | Below 1Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (BLOWER MOTOR - BODY GROUND) |
![]() |
Disconnect the D34 motor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D34-1 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (BLOWER MOTOR - BATTERY) |
![]() |
Disconnect the D34 motor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D34-3 (+B) - Body ground | Ignition switch on (IG) | 11 to 14 V |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BODY GROUND) |
![]() |
Disconnect the D37 amplifier connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D37-23 (BLW) - D37-14 (GND) | Ignition switch on (IG) Blower switch OFF | 4.5 to 5.5 V |
|
| ||||
| OK | |
| 6.CHECK AIR CONDITIONING AMPLIFIER |
![]() |
Remove the air conditioning amplifier with its connectors still connected .
Check the waveform of the amplifier connector.
| Item | Content |
| Tester Connection | D37-23 (BLW) - D37-14 (GND) |
| Tool Setting | 1 V/DIV., 500 μsec./DIV. |
| Condition | Ignition switch on (IG) Blower switch LO |
|
| ||||
| OK | ||
| ||