Home › ENGINE › 2GR-FE COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Click here.



2. SECURE ENGINE
  1. Secure the engine onto an engine stand with the bolts.



    A129635E01
  1. Remove the engine hangers.



3. REMOVE GENERATOR ASSEMBLY


    A170144
  1. Remove the terminal cap.

  1. Remove the nut and disconnect the wire harness from terminal B.

  1. Disconnect the generator connector from the generator assembly.

  1. Disconnect the connector from the compressor and magnetic clutch.

  1. Disconnect the 3 wire harness clamps.



    A170145
  1. Remove the 2 bolts, and then disconnect the bracket.



    A170146
  1. Remove the 2 bolts and the generator assembly.



    A170150
  1. Disconnect the wire harness clamp, and then remove the generator bracket.



    A170743
  1. Remove the bolt and the wire harness clamp stay.



4. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY


    A195782E01
  1. Remove the bolt, idler pulley cover plate, No. 2 idler pulley cover plate and No. 2 idler pulley sub-assembly.

    HINT:
    Plate diameter:
    Idler pulley cover plate: 33.6 mm (1.32 in.)
    No. 2 idler pulley cover plate: 37.8 mm (1.49 in.)



5. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY


    A161449
  1. Remove the 5 bolts and V-ribbed belt tensioner assembly.



6. REMOVE WATER PUMP PULLEY


    A128112E03
  1. Using SST, hold the water pump pulley.

    SST
    09960-10010   (09962-01000, 09963-00700)

  1. Remove the 4 bolts and water pump pulley.



7. REMOVE WATER INLET HOUSING


    A133375E04
  1. Disconnect the water hose.

  1. Remove the 2 bolts, nut and water inlet housing.



    A128120
  1. Remove the water inlet housing gasket and water outlet pipe O-ring.



8. REMOVE WATER PUMP ASSEMBLY


    A094889
  1. Remove the 16 bolts, water pump assembly and water pump gasket.