FRONT DRIVE SHAFT > REMOVAL |
| 1. REMOVE ENGINE UNDER COVER ASSEMBLY |
![]() |
Remove the 2 bolts and engine under cover assembly RR.
![]() |
Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.
| 2. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 6 bolts, 2 clips and No. 1 engine under cover.
| 3. REMOVE NO. 2 ENGINE UNDER COVER |
![]() |
Remove the 2 bolts and No. 2 engine under cover.
| 4. DRAIN AUTOMATIC TRANSAXLE FLUID |
Remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
| 5. REMOVE NO. 1 TRANSFER CASE PLUG |
![]() |
Remove the No. 1 transfer case plug.
Remove the No. 1 gasket from the No. 1 transfer case plug.
| 6. REMOVE TRANSFER DRAIN PLUG |
Remove the transfer drain plug and bleed the oil.
Remove the drain gasket from the transfer drain plug.
| 7. REMOVE FRONT WHEELS |
| 8. REMOVE FRONT AXLE HUB NUT LH |
![]() |
Using SST and a hammer, release the staked part of the front axle hub nut.
While applying the brakes, remove the front axle hub nut.
| 9. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH |
![]() |
Remove the nut and separate the front stabilizer link assembly from the front shock absorber.
| 10. SEPARATE FRONT SPEED SENSOR LH |
![]() |
Remove the bolt and resin clamp, and separate the front speed sensor.
| 11. SEPARATE TIE ROD ASSEMBLY LH |
Remove the cotter pin and the nut.
![]() |
Install SST to the tie rod end.
Using SST, separate the tie rod end from the steering knuckle.

| 12. SEPARATE NO. 1 FRONT SUSPENSION LOWER ARM LH |
![]() |
Remove the bolt and 2 nuts, and separate the front lower suspension arm from the front lower ball joint.
| 13. SEPARATE FRONT AXLE ASSEMBLY LH |
![]() |
Put matchmarks on the front drive shaft assembly and the front axle hub sub-assembly.
![]() |
Using a plastic hammer, separate the front drive shaft assembly from the front axle assembly.
| 14. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
Using SST, remove the front drive shaft assembly LH.
| 15. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH (for 2WD) |
![]() |
Remove the bearing bracket hole snap ring from the drive shaft bearing bracket.
Remove the bolt and front drive shaft assembly RH from the drive shaft bearing bracket.
| 16. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH (for 4WD) |
| 17. SECURE FRONT AXLE HUB SUB-ASSEMBLY LH |
![]() |
Using SST, secure the front axle hub bearing.