REAR AXLE HUB (for 2WD) > ON-VEHICLE INSPECTION |
| 1. REMOVE REAR WHEEL |
| 2. SEPARATE REAR FLEXIBLE HOSE |
![]() |
Remove the bolt and separate the rear flexible hose from the rear shock absorber with coil spring.
| 3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the 2 bolts and separate the rear disc brake caliper assembly.
| 4. REMOVE REAR DISC |
![]() |
Put matchmarks on the rear disc and the axle hub.
![]() |
Release the parking brake and remove the rear disc.
| 5. INSPECT REAR AXLE HUB BEARING LOOSENESS |
![]() |
Using a dial indicator, check for looseness near the center of the axle hub.
| 6. INSPECT REAR AXLE HUB RUNOUT |
![]() |
Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
| 7. INSTALL REAR DISC |
![]() |
Align the matchmarks and install the rear disc.
| 8. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY |
![]() |
Install the rear disc brake caliper assembly with the 2 bolts.
| 9. INSTALL REAR FLEXIBLE HOSE |
![]() |
Install the rear flexible hose to the rear shock absorber with coil spring with the bolt.
| 10. INSTALL REAR WHEEL |