Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

DTC    B2312    Driver Side Door Master Switch Malfunction

for Preparation Click here


DESCRIPTION

The portion of the power window control system that is located in the driver door consists of a power window master switch, regulator, and a motor with an integrated ECU. The driver door power window regulator motor is controlled by the ECU when the power window master switch is operated (models with jam protection).
When the ECU determines that the power window master switch is stuck, DTC B2312 is set.

NOTICE:
The power window control system uses a serial communication protocol (LIN) to communicate with the main body ECU. Inspect the communication function by following HOW TO PROCEED WITH TROUBLESHOOTING. Troubleshoot the power window control system after confirming that the communication system is functioning properly.


DTC Code
DTC Detection Condition
Trouble Area
B2312
The power window regulator master switch is stuck
  1. Power window regulator motor (on driver side)
  2. Power window master switch
  3. Wire harness
  4. Power window master switch is held in the same position for more than 20 seconds

WIRING DIAGRAM


B175977E03


INSPECTION PROCEDURE

1.CHECK DTC OUTPUT
  1. Turn the ignition switch off.

  1. Wait for at least 10 seconds, and then turn the ignition switch on (IG).

  1. Check whether the DTC output recurs.

    Result:
    Result
    Proceed to
    B2312
    A
    No output
    B



B
END (DUE TO KEEPING SWITCH OPERATED FOR 20 SECONDS OR MORE)
A


2.INSPECT POWER WINDOW MASTER SWITCH


    B164359E12
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    8 (U) - 1 (E) - 4 (A)
    Auto UP
    Below 1 Ω
    8 (U) - 1 (E)
    Manual UP
    Below 1 Ω
    5 (D) - 1 (E)
    Manual DOWN
    Below 1 Ω
    4 (A) - 5 (D) - 1 (E)
    Auto DOWN
    Below 1 Ω



NG
REPLACE POWER WINDOW MASTER SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (POWER WINDOW MASTER SWITCH - WINDOW REGULATOR MOTOR)


    B175976E06
  1. Disconnect the M1 and H1 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    M1-8 (U) - H1-10 (UP1)
    Always
    Below 1 Ω
    M1-3 (LED) - H1-5 (LED)
    Always
    Below 1 Ω
    M1-4 (A) - H1-4 (AUTO)
    Always
    Below 1 Ω
    M1-5 (D) - H1-7 (DWN1)
    Always
    Below 1 Ω
    M1-8 (U) - Body ground
    Always
    10 kΩ or higher
    M1-3 (LED) - Body ground
    Always
    10 kΩ or higher
    M1-4 (A) - Body ground
    Always
    10 kΩ or higher
    M1-5 (D) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side) (Click here)