Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Taillight Relay Circuit

for Preparation Click here


DESCRIPTION

  1. The main body ECU receives the light control switch TAIL signal to control the taillight relay.
  2. When the light control switch is in the AUTO position, the main body ECU receives the ambient light level signal from the automatic light control sensor to control the taillight relay.

WIRING DIAGRAM


E151668E01


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn Techstream on.

  1. Select the following menu items: Body Electrical / Main Body / Active Test.

  1. Check that the relay operates.

    Main Body: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Taillight Relay
    Taillight relay
    ON/OFF
    -

    OK:
    Taillight relay operates. (Taillights illuminate.)



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT FUSE (TAIL)
  1. Remove the TAIL fuse from the instrument panel junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    TAIL fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


3.INSPECT TAILLIGHT RELAY (TAIL)


    A087121E11
  1. Remove the taillight relay from the instrument panel junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    Apply the battery voltage between terminals 1 and 2
    Below 1 Ω
    3 - 4
    Voltage is not applied between terminals 1 and 2
    Below 1 Ω
    Apply the battery voltage between terminals 1 and 2
    10 kΩ or higher



NG
REPLACE TAILLIGHT RELAY
OK


4.INSPECT MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


    E151667E01
  1. Measure the voltage between the loading slot of the TAIL fuse and body ground.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    TAIL fuse terminal - Body ground
    Light control switch OFF → TAIL
    Below 1 V → 11 to 14 V



NG
Go to step 5
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (FUSE - BODY GROUND) 

5.CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK)


    E121505E04
  1. Disconnect the 1A instrument panel junction block connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    1A-1 - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)