Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System)

WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System) > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU


  1. Disconnect the main body ECU connector.


    B139428E12

  2. Measure the resistance and voltage between each terminal of the wire harness side connectors and body ground.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    1A-1 (ACC) - Body ground
    B - Body ground
    Ignition power supply (ACC signal)
    Ignition switch ACC → OFF
    10 to 14 V → Below 1 V
    1A-1 (IG) - Body ground
    B - Body ground
    Ignition power supply (IG signal)
    Ignition switch ON → OFF
    10 to 14 V → Below 1 V
    1D-10 (BECU) - Body ground
    W - Body ground
    +B power supply
    Always
    10 to 14 V
    1D-16 (ALTB) - Body ground
    W - Body ground
    +B (power system alternator system) power supply
    Always
    10 to 14 V
    D8-24 (DCTY) - Body ground
    G - Body ground
    Driver side door courtesy light switch input
    Driver side door CLOSED (OFF) → OPEN (ON)
    10 kΩ or higher → Below 1 Ω
    D7-21 (PCTY) - Body ground
    SB - Body ground
    Passenger side courtesy light switch input
    Passenger side door CLOSED (OFF) → OPEN (ON)
    10 kΩ or higher → Below 1 Ω
    D7-7 (RCTY) - Body ground*1
    GR - Body ground
    Rear courtesy light switch RH input
    Rear door RH CLOSED (OFF) → OPEN (ON)
    10 kΩ or higher → Below 1 Ω
    D7-5 (RCTY) - Body ground*2
    GR - Body ground
    Rear courtesy light switch RH input
    Rear door RH CLOSED (OFF) → OPEN (ON)
    10 kΩ or higher → Below 1 Ω
    1O-7 (LCTY) - Body ground
    B - Body ground
    Rear courtesy light switch LH input
    Rear door LH CLOSED (OFF) → OPEN (ON)
    10 kΩ or higher → Below 1 Ω
    D7-25 (BCTY) - Body ground
    L - Body ground
    Back door courtesy light switch input
    Back door CLOSED (OFF) → OPEN (ON)
    10 kΩ or higher → Below 1 Ω
    D10-5 (KSW) - Body ground
    GR - Body ground
    Unlock warning switch input
    No key in ignition key cylinder (OFF) → Key inserted (ON)
    10 kΩ or higher → Below 1 Ω
    1F-10 (GND1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    1M-9 (GND2) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω

    HINT:
    1. *1: w/ Power Back Door System
    2. *2: w/o Power Back Door System
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the main body ECU (instrument panel junction block) connectors.

  4. Measure the voltage between each terminal of the wire harness side connectors and body ground.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D7-1 (TR+) - Body ground*3
    LG - Body ground
    Back door opener motor input
    Back door CLOSED (LOCKED) → OPEN (UNLOCKED)
    Below 1 V → 10 to 14 V*1
    D9-4 (HAZ) - Body ground
    O - Body ground
    Turn signal flasher relay signal
    Any transmitter switch is pressed → not pressed
    Below 1 V → Pulse generation*2
    D10-7 (BZR) - Body ground
    R - Body ground
    Wireless door lock buzzer
    Wireless door lock buzzer OFF → ON
    Below 1 V → 10 to 14 V

    HINT:
    1. *1: When operating the motor.
    2. *2: When operating the answer back function.
    3. *3: w/o Power Back Door System