When the passenger seat belt is not fastened with the ignition switch on (IG) position and the passenger seat occupied, check that the passenger seat belt warning light on navigation receiver*1 or hazard warning switch*2 blinks. The occupant detection sensor detects if the passenger seat is occupied and sends signals to the meter assembly. The inner belt detects the passenger seat belt condition and sends signals to the meter assembly. After receiving the signals from the occupant detection sensor and inner belt, the meter assembly sends signals to navigation receiver*1 or hazard warning switch*2 to request the passenger seat belt warning light to blink or go off.
- HINT:
-
*1: w/ Navigation System
-
*2: w/o Navigation System