Home › ENGINE › 2GR-FE CHARGING › GENERATOR

GENERATOR > REASSEMBLY

for Preparation Click here



1. INSTALL GENERATOR ROTOR ASSEMBLY
  1. Place the drive end frame on the clutch pulley.



    A118367E01
  1. Install the generator rotor assembly to the drive end frame.



    A118365E01
  1. Place a new generator washer on the generator rotor.



2. INSTALL GENERATOR COIL ASSEMBLY


    A172926E01
  1. Using a deep socket wrench (21 mm) and a press, slowly press in the generator coil assembly.



    A128074
  1. Install the 4 bolts.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }



3. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY


    A079315E13
  1. While pushing the 2 brushes into the generator brush holder assembly, insert a φ1.0 mm (0.039 in.) pin into the brush holder hole.



    A079316E04
  1. Install the brush holder assembly to the generator coil with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. Pull out the pin from the generator brush holder.



4. INSTALL GENERATOR TERMINAL INSULATOR


    A128083E01
  1. Install the terminal insulator to the generator coil.

    NOTICE:
    Pay attention to the installation direction of the terminal insulator.



5. INSTALL GENERATOR REAR END COVER


    A128071
  1. Install the generator rear end cover to the generator coil with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }



6. INSTALL GENERATOR CLUTCH PULLEY
  1. Temporarily install the clutch pulley onto the rotor shaft.



    A128084E01
  1. Set SST (A) and (B).

    SST
    09820-63021  



    A160961E01
  1. Clamp SST (A) in a vise.

    NOTICE:
    Be sure to fix the flat surface of SST (A) in a vise.



    A135194E02
  1. Place the rotor shaft end into SST (A).



    A135195E02
  1. Fit SST (B) to the clutch pulley.



    A151433E01
  1. Tighten the pulley by turning SST (B) in the direction shown in the illustration.

    Torque:
    without SST:
    110 N*m{ 1125 kgf*cm , 81 ft.*lbf }
    with SST:
    84 N*m{ 857 kgf*cm , 62 ft.*lbf }

    NOTICE:
    1. Use a torque wrench with a fulcrum length of 318 mm (12.52 in.).
    2. This torque value is effective when SST is parallel to a torque wrench.
    3. Hold the generator assembly tightly.

  1. Remove the generator assembly from SST.

  1. Check that the clutch pulley rotates smoothly.

  1. Install a new clutch pulley cap to the clutch pulley.