Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH

COMPRESSOR AND MAGNETIC CLUTCH > DISASSEMBLY

for Preparation Click here



1. REMOVE MAGNETIC CLUTCH ASSEMBLY


    E150350E01
  1. Place the compressor and magnetic clutch in a vise.

    SST
    95047-10040  

  1. Using SST, hold the magnetic clutch hub.

  1. Remove the bolt, magnetic clutch hub, and magnetic clutch washers.

    HINT:
    There is no set number of magnetic clutch washers because they are used for adjustment.



    E150351
  1. Using a snap ring expander, remove the snap ring and then remove the magnetic clutch rotor.

    NOTICE:
    Take care not to damage the seal cover of the bearing when removing the snap ring.



    E150355
  1. Disconnect the connector.

  1. Disengage the clamp.

  1. Remove the screw and the bracket.



    E150353
  1. Using a snap ring expander, remove the snap ring and magnetic clutch stator.