COMPRESSOR AND MAGNETIC CLUTCH > REASSEMBLY |
| 1. INSTALL MAGNETIC CLUTCH ASSEMBLY |
![]() |
Install the magnetic clutch stator while aligning the protrusion on the stator with the notch on the air compressor assembly as shown in the illustration.
![]() |
Engage the clamp.
Install the bracket with the screw.
Connect the connector.
![]() |
Using a snap ring expander, install a new snap ring with the chamfered side facing up.
![]() |
Using a snap ring expander, install the magnetic clutch rotor and a new snap ring with the chamfered side facing up.
Install the magnetic clutch washer and magnetic clutch hub.
![]() |
Using SST, hold the magnetic clutch hub and install the bolt.
| 2. INSPECT MAGNETIC CLUTCH CLEARANCE |
![]() |
Set the dial indicator to the magnetic clutch hub.
Connect the battery positive lead to terminal 1 of the magnetic clutch connector, and the negative lead to the ground wire. Turn the magnetic clutch on and off and measure the clearance.
Remove the compressor and magnetic clutch from the vise.
| 3. ADJUST COMPRESSOR OIL LEVEL |
![]() |
When replacing the compressor and magnetic clutch with a new one, gradually discharge the refrigerant gas from the service valve, and drain the following amount of oil from the new compressor and magnetic clutch before installation.