THEFT DETERRENT SYSTEM (w/ Smart Key System) > TERMINALS OF ECU |
| CHECK MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) |
Disconnect the main body ECU (instrument panel junction block) connectors.

Measure the resistance and voltage between each terminal of the wire harness side connectors and body ground.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| D7-5 (RCTY)*1 - Body ground | GR - Body ground | Rear courtesy light switch RH input | Rear door RH CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| D7-7 (RCTY)*2 - Body ground | GR - Body ground | Rear courtesy light switch RH input | Rear door RH CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| D7-21 (PCTY) - Body ground | SB - Body ground | Passenger side courtesy light switch input | Passenger side door CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| D7-25 (BCTY) - Body ground | L - Body ground | Back door courtesy light switch input | Back door CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| D8-24 (DCTY) - Body ground | G - Body ground | Driver side door courtesy light switch input | Driver side door CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| D8-20 (GCTY)*3 - Body ground | P - Body ground | Glass hatch courtesy switch | Glass hatch CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| 1A-1 (ACC) - Body ground | B - Body ground | Ignition power supply (ACC signal) | Engine switch ON (ACC) → OFF | 11 to 14 V → Below 1 V |
| 1A-1 (IG) - Body ground | B - Body ground | Ignition power supply (IG signal) | Engine switch ON (IG) → OFF | 11 to 14 V → Below 1 V |
| 1D-16 (ALTB) - Body ground | W - Body ground | +B (power system alternator system) power supply | Always | 11 to 14 V |
| 1F-10 (GND1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| 1M-9 (GND2) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| 1O-7 (LCTY) - Body ground | B - Body ground | Rear courtesy light switch LH input | Rear door LH CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
Reconnect the main body ECU (instrument panel junction block) connectors.
Measure the voltage between each terminal of the wire harness side connectors and body ground.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| D9-4 (HAZ) - Body ground | O - Body ground | Turn signal flasher relay signal | System is in alarm sounding state | Below 1 V |
| 1D-11 (HORN) - Body ground | GR - Body ground | Vehicle horn drive | Vehicle horn is sounding (Theft deterrent system is in alarm sounding state) | Pulse generation (Below 1 V ← → 12 V) |
| CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) ASSEMBLY |
Disconnect the D39 and D40 ECU connectors.

| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| D39-24 (HSW) - Body ground | R - Body ground | Engine hood courtesy switch | Engine hood CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| D40-1 (+B) - D40-17 (E) | B - B | Battery power supply | Always | 11 to 14 V |
| D40-17 (E) - Body ground | B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the D39 and D40 ECU connectors.
Measure the voltage of the connector.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| D39-20 (SH-) - Body ground | W - Body ground | Security horn drive | Security horn is sounding (Theft deterrent system is in alarm sounding state) | Pulse generation (Below 1 V ← → 12 V) |
| D40-2 (IND) - Body ground | W - Body ground | Security indicator output | Security indicator is on (It comes on only in alarm sounding state. It flashes when immobiliser is operating.) | 3 to 6 V |