THEFT DETERRENT SYSTEM (w/o Smart Key System) > Engine Hood Courtesy Switch Circuit |

| 1.READ VALUE USING TECHSTREAM |
Connect Techstream to the DLC3.
Turn the ignition switch to the ON position.
Turn the Techstream main switch on.
Select the item below in the Data List and read the display on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Hood Courtesy Switch | Engine hood courtesy switch signal ON / OFF | ON: Engine hood is OPEN OFF: Engine hood is CLOSED | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT ENGINE HOOD COURTESY SWITCH |
Disconnect the A8 courtesy switch connector.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | LOCK position | Below 1 Ω |
| UNLOCK position | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A8-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ENGINE HOOD COURTESY SWITCH) |
![]() |
Disconnect the D8 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D8-16 (HCTY) - A8-1 | Always | Below 1 Ω |
| D8-16 (HCTY) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||