WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Key System) > TERMINALS OF ECU |
| CHECK MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) |
Disconnect the main body ECU (instrument panel junction block assembly) connectors.

Measure the resistance and voltage between each terminal of the wire harness side connectors and body ground.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| 1A-1 (IG) - Body ground | B - Body ground | Ignition power supply (IG signal) | Engine switch on (IG) → off | 10 to 14 V → Below 1 V |
| 1A-1 (ACC) - Body ground | B - Body ground | Ignition power supply (ACC signal) | Engine switch on (ACC) → off | 10 to 14 V → Below 1 V |
| 1D-16 (ALTB) - Body ground | W - Body ground | +B (power system alternator system) power supply | Always | 10 to 14 V |
| D8-24 (DCTY) - Body ground | G - Body ground | Driver side door courtesy light switch input | Driver side door CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| D7-21 (PCTY) - Body ground | SB - Body ground | Passenger side courtesy light switch input | Passenger side door CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| D7-7 (RCTY) - Body ground*1
| GR - Body ground | Rear courtesy light switch RH input | Rear door RH CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| D7-5 (RCTY) - Body ground*2
| GR - Body ground | Rear courtesy light switch RH input | Rear door RH CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| 1O-7 (LCTY) - Body ground | B - Body ground | Rear courtesy light switch LH input | Rear door LH CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| D7-25 (BCTY) - Body ground | L - Body ground | Back door courtesy light switch input | Back door CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| 1F-10 (GND1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| 1M-9 (GND2) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the main body (instrument panel J/B) connectors.
Measure the voltage between each terminal of the wire harness side connectors and body ground.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| D7-1 (TR+) - Body ground*3
| LG - Body ground | Back door opener motor | Back door CLOSED (LOCKED) → OPEN (UNLOCKED) | Below 1 V → 10 to 14 V*1
|
| D9-4 (HAZ) - Body ground | O - Body ground | Turn signal flasher relay signal | Any transmitter switch is pressed → not pressed | Below 1 V → 10 to 14 V*2
|
| CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |

Disconnect the D40 certification ECU (smart key ECU assembly) connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
| D40-17 (E) - Body ground | B - Body ground | Ground | Always | Below 1 Ω |
| D40-1 (+B) - D40-17 (E) | B - B | Battery power supply | Always | 11 to 14 V |
| D40-18 (IG) - D40-17 (E) | G - B | IG power supply | Engine switch on (IG) | 11 to 14 V |
| Engine switch off | Below 1 V |
Reconnect the D40 certification ECU (smart key ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
| D40-39 (RSSI) - D40-17 (E) | B - B | Door control receiver output signal | Engine switch off, all doors closed and transmitter switch not pressed | 11 to 14 V |
| Engine switch off, all doors closed and transmitter switch pressed | Below 1 V | |||
| D40-38 (RDA) - D40-17 (E) | Y - B | Door control receiver output signal | Engine switch off, all doors closed and transmitter switch not pressed | 4.6 to 5.4 V |
| Engine switch off, all doors closed and transmitter switch pressed | Pulse generation | |||
| D40-29 (RCO) - D40-17 (E) | V - B | Supply battery to door control receiver | Engine switch off, all doors closed and transmitter switch pressed | 4.6 to 5.4 V |
| D40-21 (BZR) - Body ground | R - Body ground | Wireless door lock buzzer signal | Wireless door lock buzzer OFF → ON | Below 1 V → Pulse generation |