Home › DRIVE LINE › MF2A TRANSFER › BEARING RETAINER OIL SEAL

BEARING RETAINER OIL SEAL > REMOVAL

for Preparation Click here



1. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



2. REMOVE NO. 1 TRANSFER CASE PLUG


    C082977E04
  1. Remove the No. 1 transfer case plug.

  1. Remove the No. 1 gasket from the No. 1 transfer case plug.



3. REMOVE TRANSFER DRAIN PLUG
  1. Remove the transfer drain plug and bleed the oil.

  1. Remove the drain gasket from the transfer drain plug.



4. REMOVE ENGINE UNDER COVER ASSEMBLY


5. REMOVE NO. 1 ENGINE UNDER COVER


6. REMOVE NO. 2ENGINE UNDER COVER


7. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



8. REMOVE FRONT WHEEL


9. REMOVE FRONT AXLE HUB NUT


    C167528E01
  1. Using SST and a hammer, release the staked part of the front axle hub nut.

    SST
    09930-00010  

    NOTICE:
    Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.

  1. While applying the brakes, remove the front axle hub nut.



10. SEPARATE FRONT STABILIZER LINK ASSEMBLY


    C165915
  1. Remove the nut and separate the front stabilizer link assembly from the front shock absorber.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.



11. SEPARATE FRONT SPEED SENSOR


    C167708
  1. Remove the bolt and clamp, and separate the front speed sensor and front flexible hose.



12. SEPARATE TIE ROD END SUB-ASSEMBLY

HINT:
Perform the same procedure as for the LH side.



13. SEPARATE NO. 1 FRONT SUSPENSION LOWER ARM


    C165929
  1. Remove the bolt and 2 nuts, and separate the front lower suspension arm from the front lower ball joint.



14. SECURE FRONT AXLE HUB SUB-ASSEMBLY


    C166269E01
  1. Remove the 2 bolts, 2 nuts and front axle assembly.

    NOTICE:
    When removing the nuts, keep the bolts from rotating.



15. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH (for 2WD)


    C167529
  1. Remove the bearing bracket hole snap ring from the drive shaft bearing bracket.

  1. Remove the bolt and front drive shaft assembly RH from the drive shaft bearing bracket.

    NOTICE:
    Do not damage the boot or oil seal.



16. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH (for 4WD)

HINT:
Perform the same procedure as for the LH side.



17. FRONT DRIVE SHAFT HOLE SNAP RING


    C057543E04
  1. Using a screwdriver, remove the front drive shaft hole snap ring.



18. REMOVE TRANSFER RH BEARING RETAINER OIL SEAL


    C083628E02
  1. Using SST, remove the transfer RH bearing retainer oil seal.

    SST
    09308-00010  

    NOTICE:
    Do not damage the oil-seal-fitted surface of the case.