REAR DIFFERENTIAL CARRIER OIL SEAL > REMOVAL |
| 1. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY |
![]() |
Depress the brake pedal and hold it.
Using a hexagon wrench (6 mm), loosen the cross groove joint set bolts 1/2 turn.
![]() |
Place matchmarks on the rear propeller shaft and rear drive pinion flange sub-assembly.
Remove the 4 nuts, 4 bolts and 4 washers.
![]() |
Remove the 4 bolts and 4 adjusting shims.
![]() |
Using a brass bar and a hammer, remove the propeller shaft with center bearing shaft assembly.
![]() |
Insert SST into the transfer to prevent oil leakage.
| 2. REMOVE REAR DIFFERENTIAL FILLER PLUG |
![]() |
Using a hexagon wrench (10 mm), remove the rear differential filler plug and rear differential filler plug gasket.
| 3. REMOVE REAR DIFFERENTIAL DRAIN PLUG |
![]() |
Using a hexagon wrench (10 mm), remove the rear differential drain plug and rear differential drain plug gasket, and drain the oil.
| 4. REMOVE REAR DRIVE PINION NUT |
![]() |
Using SST and a hammer, unstake the staked part of the rear drive pinion nut.
![]() |
Using SST to hold the rear drive pinion companion flange sub-assembly, remove the rear drive pinion nut.
| 5. REMOVE REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY |
![]() |
Using SST, remove the rear drive pinion companion flange sub-assembly.
| 6. REMOVE REAR DIFFERENTIAL CARRIER OIL SEAL |
![]() |
Using SST, remove the rear differential carrier oil seal.
| 7. REMOVE REAR DIFFERENTIAL DRIVE PINION OIL SLINGER |
| 8. REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING |
![]() |
Using SST, remove the rear drive pinion front tapered roller bearing.
| 9. REMOVE REAR DIFFERENTIAL DRIVE PINION BEARING SPACER |