Home › DRIVE LINE › PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY

PROPELLER SHAFT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT SPIDER BEARING


    C166052
  1. Check the spider bearing axial play by turning the flange while holding the shaft tightly.

    HINT:
    If necessary, replace the propeller with center bearing shaft assembly.



2. INSPECT INTERMEDIATE SHAFT


    C166053
  1. Using a dial indicator, inspect the runout of the intermediate shaft.

    Maximum runout:
    0.4 mm (0.016 in.)

    HINT:
    If the shaft runout exceeds the maximum, replace the propeller with center bearing shaft assembly.



    C166054
  1. Using a dial indicator, inspect the runout of the front side of the intermediate shaft flange.

    Maximum runout:
    0.1 mm (0.004 in.)

    HINT:
    If the intermediate shaft flange runout exceeds the maximum, replace the propeller with center bearing shaft assembly.



    C166055
  1. Using a dial indicator, inspect the runout of the rear side of the intermediate shaft flange in the horizontal direction.

    Maximum runout:
    0.1 mm (0.004 in.)

    HINT:
    If the intermediate shaft flange runout exceeds the maximum, replace the propeller with center bearing shaft assembly.



    C166056
  1. Using a dial indicator, inspect the runout of the rear side of the intermediate shaft flange in the vertical direction.

    Maximum runout:
    0.1 mm (0.004 in.)

    HINT:
    If the intermediate shaft flange runout exceeds the maximum, replace the propeller with center bearing shaft assembly.



3. INSPECT PROPELLER SHAFT ASSEMBLY


    C166057
  1. Using a dial indicator, inspect the runout of the propeller shaft.

    Maximum runout:
    0.4 mm (0.016 in.)

    HINT:
    If the shaft runout exceeds the maximum, replace the propeller with center bearing shaft assembly.



4. INSPECT NO. 2 CENTER SUPPORT BEARING ASSEMBLY


    C166058
  1. Turn the bearing by hand while applying force in the rotation direction. Check that the bearing turns smoothly.

  1. Check that the seals are not cracked or damaged.

    HINT:
    If the bearing is damaged, worn, or does not turn freely, replace it.



5. INSPECT NO. 1 CENTER SUPPORT BEARING ASSEMBLY
  1. Inspect the No. 1 center support bearing assembly by following the same procedures as the No. 2 center support bearing assembly.



6. INSPECT REAR PROPELLER SHAFT


    C167205
  1. Using a dial indicator, inspect the runout of the rear propeller shaft.

    Maximum runout:
    0.4 mm (0.016 in.)

    HINT:
    If the shaft runout exceeds the maximum, replace the propeller with center bearing shaft assembly.