Home › DRIVE LINE › PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY

PROPELLER SHAFT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE PROPELLER SHAFT ASSEMBLY


    C166043E01
  1. Place matchmarks on both the flanges.

  1. Remove the 4 nuts, 4 bolts and 4 washers.



2. REMOVE INTERMEDIATE SHAFT


    C166044E01
  1. Place matchmarks on the rear flange and rear propeller shaft.

    NOTICE:
    Do not make matchmarks with a punch.

  1. Using a hexagon wrench (6 mm), remove the 6 bolts and 2 washers and remove the intermediate shaft from the rear propeller shaft.



3. REMOVE NO. 2 CENTER SUPPORT BEARING ASSEMBLY


    C167278E01
  1. Place matchmarks on the rear flange and intermediate shaft.



    C167280E01
  1. Using SST and a hammer, unstake the staked part of the nut.

    SST
    09930-00010  



    C166045E01
  1. Using SST to hold the front flange, remove the nut and plate washer.

    SST
    09330-00021  



    C166047E01
  1. Using SST, remove the rear flange.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04061, 09957-04010, 09957-04010)

  1. Remove the No. 2 center support bearing assembly and washer.



4. REMOVE NO. 1 CENTER SUPPORT BEARING ASSEMBLY


    C167276E01
  1. Place matchmarks on the front flange and intermediate shaft.



    C166071E01
  1. Using SST and a hammer, unstake the staked part of the nut.

    SST
    09930-00010  



    C166049E02
  1. Using SST to hold the front flange, remove the nut and plate washer.

    SST
    09330-00021  



    C166051E01
  1. Using SST, remove the front flange.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04061, 09957-04010, 09958-04011)

  1. Remove the No. 1 center support bearing assembly and plate washer.



5. REMOVE SLIDING SHAFT DUST COVER


    C167116
  1. Hold the intermediate shaft assembly between aluminum plates in a vise.

  1. Using a screwdriver and a hammer, remove the sliding shaft dust cover.