AIR FUEL RATIO SENSOR > REMOVAL |
| 1. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
![]() |
Disconnect the air fuel ratio sensor connector and remove the clamp.
![]() |
Using SST, remove the sensor from the exhaust manifold sub-assembly LH.
| 2. REMOVE ENGINE UNDER COVER ASSEMBLY |
![]() |
Remove the 2 bolts and engine under cover assembly RR.
![]() |
Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.
| 3. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 6 bolts, 2 clips and No. 1 engine under cover.
| 4. REMOVE NO. 2 ENGINE UNDER COVER |
![]() |
Remove the 2 bolts and No. 2 engine under cover.
| 5. REMOVE FRONT FLOOR COVER LH |
![]() |
Remove the 3 clamps, 6 bolts and front floor cover LH.
| 6. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD) |
![]() |
Depress the brake pedal and hold it.
Using a hexagon wrench (6 mm), loosen the cross groove joint set bolts 1/2 turn.
![]() |
Place matchmarks on the rear propeller shaft and rear drive pinion flange sub-assembly.
Remove the 4 nuts, 4 bolts and 4 washers.
![]() |
Remove the 4 bolts and 4 adjusting shims.
![]() |
Using a brass bar and a hammer, remove the propeller shaft with center bearing shaft assembly.
![]() |
Insert SST into the transfer to prevent oil leakage.
| 7. REMOVE TAIL EXHAUST PIPE ASSEMBLY |
![]() |
Remove the 2 bolts and 2 compression springs.
Disconnect the exhaust pipe support and remove the tail exhaust pipe assembly.
Remove the gasket from the center exhaust pipe assembly.
| 8. REMOVE CENTER EXHAUST PIPE ASSEMBLY |
![]() |
Remove the 2 bolts and 2 compression springs.
Disconnect the 3 exhaust pipe supports and remove the center exhaust pipe assembly.
Remove the gasket from the No. 3 exhaust pipe sub-assembly.
| 9. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY |
![]() |
Remove the 3 clamps and disconnect the heated oxygen sensor (for bank 1 sensor 2) connector.
![]() |
Remove the 2 bolts, 2 nuts and front No. 3 exhaust pipe sub-assembly.
Remove the 2 gaskets from the front No. 3 exhaust pipe sub-assembly.
| 10. REMOVE MANIFOLD STAY |
![]() |
Remove the bolt, nut and manifold stay.
| 11. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH |
![]() |
Disconnect the air fuel ratio sensor (for bank 1 sensor 1) connector and remove the clamp.
![]() |
Remove the 6 nuts and exhaust manifold sub-assembly RH.
Remove the gasket.
| 12. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
![]() |
Using SST, remove the air fuel ratio sensor from the exhaust manifold sub-assembly RH.