Home › STEERING › POWER STEERING › POWER STEERING SYSTEM

POWER STEERING SYSTEM > FAIL-SAFE CHART

for Preparation Click here


If a problem occurs in the power steering system, the P/S warning light will come on in the combination meter and steering power assist will be stopped, fixed at a particular point, or decreased simultaneously to protect the system.

Power Steering System: 
DTC No.
Detection Condition
Fail-safe
C1513
Torque sensor malfunction
Power assist stops
C1514
C1521
Motor malfunction
C1524
C1528
Motor rotation angle sensor malfunction
C1531
ECU malfunction
C1532
C1533
Assist force restricted
C1554
Power source relay malfunction
Power assist stops
C1555
Motor relay malfunction
U0073
CAN bus malfunction
Amount of power assist is locked at the 140 km/h (87 mph) level of power assist
U0100
ECM communication error
Power assist stops
U0129
Skid control ECU communication error
Amount of power assist is locked at the 140 km/h (87 mph) level of power assist

HINT:
The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the engine idling.