LIGHTING SYSTEM > Door Mirror Foot Light Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM |
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn Techstream on.
Select the following menu items: Body Electrical / Main Body / Active Test.
Check the operation.
| Item | Test Details | Diagnostic Note |
| Side Mirror Foot Light | Door mirror foot lights ON / OFF | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) |
![]() |
Disconnect the D7 main body ECU connector.
Using a service wire, connect D7-4 of the wire harness side and body ground.
|
| ||||
| OK | ||
| ||
| 3.INSPECT FUSE (G/H) |
Remove the G/H fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G/H fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.INSPECT DOOR MIRROR FOOT LIGHT RELAY (MIR LP) |
![]() |
Remove the door mirror foot light relay from the No. 2 engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Apply the battery voltage between terminals 1 and 2 | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (BATTERY - DOOR MIRROR FOOT LIGHT RELAY) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Door mirror foot light relay terminal 5 - Body ground | Always | 11 to 14 V |
| Door mirror foot light relay terminal 2 - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (DOOR MIRROR FOOT LIGHT RELAY - MAIN BODY ECU) |
Disconnect the D7 main body ECU connector.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Door mirror foot light relay terminal 1 - D7-4 (MLRY) | Always | Below 1 Ω |
| D7-4 (MLRY) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||