Home › ENGINE › 2GR-FE EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER ASSEMBLY


    A171849
  1. Remove the 2 bolts and engine under cover assembly RR.



    A171850
  1. Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.



2. REMOVE NO. 1 ENGINE UNDER COVER


    A171855
  1. Remove the 6 bolts, 2 clips and No. 1 engine under cover.



3. REMOVE NO. 2 ENGINE UNDER COVER


    A171854
  1. Remove the 2 bolts and No. 2 engine under cover.



4. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    A170139
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the exhaust pipe support and remove the tail exhaust pipe assembly.

  1. Remove the gasket from the center exhaust pipe assembly.



5. REMOVE EXHAUST PIPE DAMPER


    A174261
  1. Remove the 2 bolts and exhaust pipe damper.



6. REMOVE CENTER EXHAUST PIPE ASSEMBLY


    A170125
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the 3 exhaust pipe supports and remove the center exhaust pipe assembly.

  1. Remove the gasket from the No. 3 exhaust pipe sub-assembly.



7. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY


    A171743
  1. Remove the 3 clamps and disconnect the heated oxygen sensor (for bank 1 sensor 2) connector.



    A170126
  1. Remove the 2 bolts, 2 nuts and front No. 3 exhaust pipe sub-assembly.

  1. Remove the 2 gaskets from the front No. 3 exhaust pipe sub-assembly.



8. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    A172497E01
  1. Using SST, remove the heated oxygen sensor from the front No. 3 exhaust pipe sub-assembly.

    SST
    09224-00010  



9. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A171745
  1. Disconnect the heated oxygen sensor (for bank 2 sensor 2) connector.



    A170127
  1. Loosen the bolt.

  1. Remove the 2 nuts and front exhaust pipe assembly.

  1. Remove the gasket from the front exhaust pipe assembly.



10. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A172498E01
  1. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

    SST
    09224-00010