Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

DTC    B1446/46    Air Mix Damper Control Servo Motor Circuit (Driver Side)

for Preparation Click here


DESCRIPTION

The air mix control servo motor sends pulse signals to indicate the damper position to the air conditioning amplifier. The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the air mix damper (driver side) to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the blown air.

HINT:
Confirm that there are no mechanical problems because this DTC can be set if either a damper link or damper is mechanically locked.


DTC No.
DTC Detection Condition
Trouble Area
B1446/46
Air mix damper position does not change even if air conditioning amplifier operates air mix damper control servo motor
  1. Air mix control servo motor
  2. Air conditioning harness
  3. Air conditioning amplifier

WIRING DIAGRAM


E133419E08


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch on (IG) and turn Techstream main switch on.

  1. Select the items below in the Data List, and read the value displayed on Techstream.

    Data List / Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Mix Sensor Targ Pulse(D)
    Driver side air mix control servo motor target pulse /
    Min.: 0, Max.: 255
    MAX. COLD: 5 (pulse)
    MAX. HOT: 103 ()pulse
    -

    OK:
    The display is as specified in the normal condition column.


    Result:

    Result
    Proceed to
    NG
    A
    OK (Checking from PROBLEM SYMPTOMS TABLE)
    B
    OK (Checking from DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER
A


2.REPLACE AIR MIX CONTROL SERVO MOTOR
  1. Replace the air mix control servo motor .


NEXT


3.CHECK DTC OUTPUT
  1. Clear the DTC (Click here).

  1. Check for DTC (Click here).

    OK:
    DTC B1446/46 is not output.



NG
REPAIR OR REPLACE AIR CONDITIONING HARNESS
OK

END (AIR MIX CONTROL SERVO MOTOR IS DEFECTIVE)