Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT RELAY

FOG LIGHT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT FOG LIGHT RELAY


    B060778E86
  1. Remove the front fog light relay from the center relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Apply battery voltage between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the front fog light relay.